Posted: Sat Oct 25, 2014 15:37 Post subject: Bricked WDR3600
Hi all,
Unfortunally i did something stupid by writing webupgrade firmware in SSH...
My router is now bricked. Only shows the power LED.
I installed TFTP32 and put the router is recoverymode. Tried with stock TPLINK and all av. at the DD-WRT website.
After the firware is picked up by the router; it just reboots back to the power LED.
On the Stock firmware the WPS icon (recovery) stays lit for 1-2 minutes and then the router reboots and goes back to the power LED.
The router is rev. 1.2
Anyone know what i else i can do? I have no serial-cable wire to try that.
The instructions as shown on the link that you have tried specified to use a tftp server but tftp2 that you used is a tftp client. Try the tftpd32 as recommended or solarwinds or PumpKIN.
In case you still have problem after using tftp server, try use a XP computer with 100M network cards (my experience with my F5D8235-4 v2 which may or may not applies to your case).
The instructions as shown on the link that you have tried specified to use a tftp server but tftp2 that you used is a tftp client. Try the tftpd32 as recommended or solarwinds or PumpKIN.
In case you still have problem after using tftp server, try use a XP computer with 100M network cards (my experience with my F5D8235-4 v2 which may or may not applies to your case).
Thank you for the reply. I used TFTP32 from here: http://tftpd32.jounin.net/
Sorry i did not explain it correctly, i wil change.
I am using Windows 8.1 and TFTPD32 is being found by the router on IP 192.168.1.66.
As per this openwrt wiki: http://wiki.openwrt.org/toh/tp-link/tl-wdr3600 , it seems that TFTP method may only works on some version 1.5 routers. If it doesn't work for you, may be you need to try serial approach.