Author
Message
ornob912 DD-WRT Novice Joined: 26 Jul 2014 Posts: 4
Posted: Sat Jul 26, 2014 11:50 Post subject: NetComm NF7
Hi Team,
DD-WRT support would rock for this low cost device.
Due to the fibre optic network being rolled out across AUS these devices will be quite popular as one ISP is giving them away.
Pics attached.
Back to top
Sponsor
ornob912 DD-WRT Novice Joined: 26 Jul 2014 Posts: 4
Posted: Sat Jul 26, 2014 12:10 Post subject:
more pics
Back to top
Malachi DD-WRT Guru Joined: 17 Jul 2012 Posts: 7209 Location: Columbus, Ohio
Posted: Sat Jul 26, 2014 12:35 Post subject:
According to their website it's an adsl modem/router combo.
Those are not supported by dd-wrt. _________________ I am far from a guru, I'm barely a novice.
Back to top
ornob912 DD-WRT Novice Joined: 26 Jul 2014 Posts: 4
Posted: Sat Jul 26, 2014 12:56 Post subject:
more pics
Back to top
ornob912 DD-WRT Novice Joined: 26 Jul 2014 Posts: 4
Posted: Sat Jul 26, 2014 12:58 Post subject:
Malachi wrote: According to their website it's an adsl modem/router combo.
Those are not supported by dd-wrt.
Hmmm. OK then, thanks for the clarification.
Back to top
Cheater512 DD-WRT Novice Joined: 09 Jan 2015 Posts: 1
Posted: Fri Jan 09, 2015 3:35 Post subject:
Malachi wrote: According to their website it's an adsl modem/router combo.
Those are not supported by dd-wrt.
No it isn't. It is certainly only a gigabit router, 4 gigabit LAN, 1 gigabit WAN + wifi. No ADSL.
http://www.netcommwireless.com/product/wifi/nf7
Back to top
timoshea DD-WRT Novice Joined: 21 Aug 2016 Posts: 1
Posted: Sun Aug 21, 2016 2:06 Post subject: Netcomm NF7
I have a Netcomm NF7 N300 router built November 2012, with the following components:
CPU: RALink RT6856F 700Mhz MIPS32 "34KEc"
Ethernet switch: Atheros AR8327-BL 1 A
Wireless: RALink RT5392L (802.11 abgn)
RAM: 512MB DDR2-800 (5-5-5)
CMOS Flash: 64MB MXIC 25L6406E
Ports: 1 x WAN
5 x LAN
JTAG 14 pin (unpopulated)
Is this router a suitable candidate for one or another version of DD-WRT?
If no current version is suitable, what would be the procedure for building something that's likely to work?
NOTE: Some versions of this router did come with an ADSL port. But the version I have was issued by TPG for use on the NBN.
Back to top