[thabiso]

Hi everyone,

I setup a client bridged connection according to the related wiki page:
http://www.dd-wrt.com/wiki/index.php/Client_Bridged

I'm using twice the exact same router WNDR3700v2 with DD-WRT on both of them (v24-sp2 (03/25/13) - SVN revision 21061).

Most of the client bridge setup is working like a charm, eg:
1. PC connected by cable on the secondary router can access Internet
2. Printer connected by cable on the secondary router receives a DHCP IP address


But some other things are not working or strange:
1. the printer only shows up in the active client list on the secondary router, not on the primary
2. On the other hand, my PC connected on secondary router shows up in the active client list on both routers
3. On the secondary router the active clients "hostname" is not listed, I only see a *, where as on the primary router every client has a proper hostname

4. most annoying: I cannot print from computers connected to the primary router. Printing from a computer connected to the secondary router (where the printer is connected) works fine.

I would be very grateful for all indications to solve this issue. It's probably just a minor settings error but I'm unfortunately not capable of detecting it.

Thank you best regards

Thabiso

[tatsuya46]

update to latest build ftp in sig

relayd & upnp now work though client bridge starting at r24461, the printer may require 1 or both of those

[dcrst75]

new build on yours device from 26/07./2014. When on ftp?

[tatsuya46]

private test build im not allowed to give it out. the next public build is supposed to be soon

[dcrst75]

ok...thanks
On public r24461 I have problem in WDS mode: lose GUI access, but WDS work. You known this issue? Is real and fix this on future build?
For that reason I asked of build I see on yours units

[thabiso]

Thank you very much, tatsuya46

The printer is now working from any computer in the network.

Best regards

Thabiso