Posted: Fri Aug 08, 2014 11:49 Post subject: Is USB Printing going to be supported in Kong K3 ARM?
I have looked many many places did many many search's but am unable to get usb printing to working.
This is where I am at right now.
Im running DD-WRT v24-sp2 (08/01/14) kongac i can do a lsusb and i see
root@DD-WRT:~# lsusb
Bus 001 Device 001: ID 1d6b:0002
Bus 002 Device 001: ID 1d6b:0001
Bus 003 Device 001: ID 1d6b:0002
Bus 004 Device 001: ID 1d6b:0003
When i turn it on and do that lsusb is see
root@DD-WRT:~# lsusb
Bus 001 Device 004: ID 03f0:b511
Bus 001 Device 001: ID 1d6b:0002
Bus 002 Device 001: ID 1d6b:0001
Bus 003 Device 001: ID 1d6b:0002
Bus 004 Device 001: ID 1d6b:0003
so it sees it but I assume I need to install drivers or something? Running Kongs dd-wrt.v24-K3_AC_ARM_STD.bin
I Have already turned on usb for drives and printers. Already redirected my printer to tcp/ip 192.168.1.1 raw 9100 but nothing prints Sad
root@DD-WRT:/jffs/etc# dmesg | grep usb
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
usb 1-1: new high-speed USB device number 2 using ehci-pci
usbcore: registered new interface driver usb-storage
usb-storage 1-1:1.0: USB Mass Storage device detected
scsi0 : usb-storage 1-1:1.0
usbcore: registered new interface driver usblp
usb 1-2: new high-speed USB device number 3 using ehci-pci
usblp 1-2:1.0: usblp0: USB Bidirectional printer dev 3 if 0 alt 0 proto 2 vid 0x
03F0 pid 0xB511
usb 1-1: USB disconnect, device number 2
usb 1-2: USB disconnect, device number 3
usblp0: removed
usb 1-2: new high-speed USB device number 4 using ehci-pci
usblp 1-2:1.0: usblp0: USB Bidirectional printer dev 4 if 0 alt 0 proto 2 vid 0x
03F0 pid 0xB511
usb 1-2: USB disconnect, device number 4
usblp0: removed
usb 1-2: new high-speed USB device number 5 using ehci-pci
usblp 1-2:1.0: usblp0: USB Bidirectional printer dev 5 if 0 alt 0 proto 2 vid 0x
03F0 pid 0xB511
usb 1-2: USB disconnect, device number 5
usblp0: removed
usb 1-2: new high-speed USB device number 6 using ehci-pci
usblp 1-2:1.0: usblp0: USB Bidirectional printer dev 6 if 0 alt 0 proto 2 vid 0x
03F0 pid 0xB511
root@DD-WRT:/jffs/etc#