Hi guys, I am on a relatively older build 24160. Which has been pretty stable for my needs. I am interesting in trying the new build which im sure has some ath9k fixes.
Should I even try a webflash upgrade (with settings reset). Or should I tftp?
Status: Working (sort of; see below)
Reset: no
Errors: disconnects from modem; requires reboot (from GUI) to reconnect.
Went back to previous stable build (6/23/14) and all seemed fine, however it started to do the same thing all of a sudden, with the router requiring a full power-off to come back online. This behavior was not happening prior to the installation of this new update.
edit: hasn't disconnected with the 6/23/14 firmware since I hard-rebooted the router, so could have just been an anomaly (probably was, just bad timing.) But it was happening quite consistently with the new one. I may try re-installing the new firmware again and try replicating the behavior just to make sure.
Last edited by hfelsh on Wed Dec 03, 2014 10:43; edited 1 time in total
This is historical build such in this build the HTTPS is working at last in my router
I confirm that HTTPS is finally working on TL-WR740N v3.0, as well.
However, is DD-WRT using SSL v3? I need to set minimum SSL to v3 using SSL Version Control, in FireFox, to get things working. Else I get a not-very-helpful "The connection was reset" error...
The switch is still not working properly: traffic does not pass between switch ports, that is. But this workaround still works to fix that:
Status: OK
Reset: Yes
Errors: None show-stopping, so far. Just the SSLv3 and Switch issues referred to above.
Edit: Further observations:
* Asia\Amman timezone! Yay! Hopefully this is set correctly. It should be "GMT+2 normally. DST (GMT+3) from last Friday of March at midnight to last Friday of October at 01:00", in case the info is useful to anyone.
* "cfg80211: Invalid regulatory domain detected:" syslog message at bootup. Changing the regulatory domain or channel does not help. Previous build I'm using (R22118. It's been a while since I updated) does not send this message. Not a big deal, as things are working. Though I'd like to know why this happens, if possible.
* Setting half- or quarter-channel width results in the radio turning off, even though the status page shows it as still on. This would have been awesome, had it worked: I have areas of spotty coverage where I'd like to deploy extra APs...
* Trying to use the QSS button to turn the radio off does not work. Radio seems to turn off for a moment (the led turns off), but then turns back on immediately. Not a big deal: would only have been useful for troubleshooting, anyway.
Status: working
Reset: yes
Errors:http acces not available ?
I flashed this fw , because the previous version gives also troubles accesing the web interface. I did the 30/30/30 factory reset and flashed this version but stil can acces the webinterface after I placed the backuped config back.
This config was working 100% before 25408 .
Somebody who can help me ?
Joined: 22 Jun 2014 Posts: 126 Location: Pfalz, Germany
Posted: Wed Dec 03, 2014 14:18 Post subject:
the cosmic gate wrote:
a lot of work for me to reconfigure
If you get back your router to work try following.
- Set router to default over gui
- flash r25408
- restore the r25408 config file
- upgrade over the gui to r25527
- backup your config.
now you can restore to factory defaults and restore your settings (using the new generated files !) _________________ TP-Link WDR4300 v1.2 --> last really stable release: r26622
Current testing: TP-Link AC2600
