On DIR-600b2 installs ok, factory reset mounts MAC 00:11:22:33:44:57 on LAN and WLAN. Has to be deleted on bridge MAC configuration to circumvent hangs after changes and reboots.
SES button still not functional for WLAN up/down (gpio poll 0 pressed 00).
factory reset mounts MAC 00:11:22:33:44:57 on LAN and WLAN. Has to be deleted on bridge MAC configuration to circumvent hangs after changes and reboots.
How did you manage to permanently change this MAC-Address?? _________________ Linksys WRT54GL v.1.1
Netgear WG602 (v3/v4)
fwiw, I just upgraded a DIR-615 rev D2 running r25179 to r25544.
It appeared to boot up fine. I think I then restored factory settings and it still booted up fine. But when I made one simple change, WAN Connection mode: Disabled. Rebooted.
Could not bring up the GUI. ie. r25544 not recommended for DIR-615 rev D.
Regarding duplicated WAN and LAN MAC addresses. I saw this in r25179 too after upgrading from r20453 and keeping old settings.
I notice after I restored r25179 factory web flash using emergency room and did a full reset, the WAN and LAN MAC addresses were not duplicated any more.
Where others ppl had observed duplicated WAN and LAN MAC addresses, did they reset all settings or keep settings during FW upgrade?
I observed these strange 00:11:22:33 etc MAC address, but after I make the settings and reboot, the addresses change to the normal ones. This I observed also on previous firmwares, not only these newer ones, so I guess it's not a big problem...
go to setup tab and then the subordinate network tab. change the Root MAC to Physical LAN MAC.
press save below and apply or powercycle
I think that was about what I did
go to setup tab and then the subordinate network tab. change the Root MAC to Physical LAN MAC.
press save below and apply or powercycle
I think that was about what I did
I can't find that. Please specify clearly, in detail, which TABs do you click after you access 192.168.1.1. Thanks !