Your reports for Ralink-based routers are highly appreciated !!
Router Model:
Status:
Reset:
Errors: _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Last edited by KrypteX on Wed Feb 25, 2015 9:37; edited 4 times in total
Router Model: D-Link DIR-615 D2
Firmware: DD-WRT v24-sp2 (02/24/15) std - build 26348
Kernel: Linux 3.2.66 #14265 Tue Feb 24 08:43:36 CET 2015 mips
Status: OK
Reset: Restored Factory Defaults before and after webflash from 26339
Errors: NO _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Last edited by KrypteX on Tue Feb 24, 2015 12:16; edited 1 time in total
Router Model: DIR-810L A1
Status: BAD
Reset: 30/30/30
Errors: a lot of errors (mostly same as older builds) mostly 5ghz tested
Client bridge not in options
AC-wireless not in options
Radio 5ghz "Not available! Please enable Wireless Network" after select: Repeater, Repeater
bridge and click "Site Survey" or nothing found.
Radio 5ghz status "Unknown " (turned off) after select: Client, Adhoc
"Repeater" and "Repeater bridge" on 5ghz disconnect every few seconds from AP (~7 sec.)
Wireless > WL1-WDS > Lazy WDS (nothing selected default)
"Site Survey" not work in AP mode in 5ghz
After add 5ghz "Virtual Interfaces" router hung - reset needed
Status > Wireless > Encryption - Interface wl1 show status Enabled but it's disabled
System Information > Router Model show Dlink DIR-810L B1 but my is A1
2,4ghz max Rate 144 Mb/s only when channel width set to 20 MHz
Sometimes 5GHz band dissapearing -restart needed (or two)
In "repeater bridge" 5ghz mode device not trying connect with AP on different channels, after reboot trying connect on some other random channel.
Posted: Wed Mar 04, 2015 7:52 Post subject: 2.4 GHz not working properly
It seemed to work perfectly on my new Netgear R7000 router. However, I was using 5 GHz 802.11ac all the time. Yesterday I found out that 2.4 GHz 802.11n was only at 0.5 Mbps throughput at a couple of meters compared to 200 Mbps for ac.
I went back to the Netgear stock firmware and I get back to around 60 Mbps for 802.11n.
Is there something wrong with this release and 2.4 GHz radio?
I tried various configuration settings for this.
@renek
You're in the wrong section, R7000 is Broadcom-based, please report in the Broadcom section. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
