Selected changelog (since 26348):
[26360-26361] Fixed: NAS http://svn.dd-wrt.com/ticket/4003
[26355-26359,26362-26366] Added: HT20/HT40 Info status for Wireless Clients
[26366] Broken: [Ralink] Wireless Clients show Info status "N/A" http://svn.dd-wrt.com/ticket/4008 (fix in 26381)
Your reports for Ralink/Mediatek routers are highly appreciated !!
Router Model:
Status:
Reset:
Errors: _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Last edited by KrypteX on Sat Feb 28, 2015 9:56; edited 20 times in total
Router Model: D-Link DIR-615 H2
Firmware: upgrade from r26339 to r26372
Status: OK
Reset: no 30/30/30 reset
retained setting from old build
Errors: Ticket #3544 http://svn.dd-wrt.com/ticket/3544, blocking WiFi clients from accessing router page doesn't work _________________ Asus RT-AC87U
DD-WRT v3.0-r36596 std
Last edited by javanse on Fri Feb 27, 2015 17:35; edited 1 time in total
Router Model: D-Link DIR-615 D2
Firmware: DD-WRT v24-sp2 (02/26/15) - build 26372
Kernel: Linux 3.2.66 #14409 Thu Feb 26 09:10:42 CET 2015 mips
Status: OK
Reset: 30/30/30 reset before and after webflash from 26348
Errors: NO
The newly introduced "Info" column on Wireless Status page should say "HT20" or "HT40", but says "N/A" for Ralink. So much for improvements... Bummer.
Ticket opened: http://svn.dd-wrt.com/ticket/4008 _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Router Model: DIR-810L A1
Status: BAD
Reset: 30/30/30
Errors: a lot of errors (mostly same as older builds) mostly 5ghz tested
Client bridge not in options
AC-wireless not in options
Radio 5ghz "Not available! Please enable Wireless Network" after select: Repeater, Repeater
bridge and click "Site Survey" or nothing found.
Radio 5ghz status "Unknown " (turned off) after select: Client, Adhoc
"Repeater" and "Repeater bridge" on 5ghz disconnect every few seconds from AP (~7 sec.)
Wireless > WL1-WDS > Lazy WDS (nothing selected default)
"Site Survey" not work in AP mode in 5ghz
After add 5ghz "Virtual Interfaces" router hung - reset needed
Status > Wireless > Encryption - Interface wl1 show status Enabled but it's disabled
System Information > Router Model show Dlink DIR-810L B1 but my is A1
2,4ghz max Rate 144 Mb/s only when channel width set to 20 MHz
Sometimes 5GHz band dissapearing -restart needed (or two)
In "repeater bridge" 5ghz mode device not trying connect with AP on different channels, after reboot trying connect on some other random channel.
