I am using a WHR-300HP2 as a vpn client to send home with someone so they can access my network remotely. As part of this I wanted to setup the wireless capabilities but have them disabled unless the user presses the AOSS button as per the guide linked below. I have tried both the settings under services as well as a script as mentioned below that (IE a startup script disables the wireless radio interface and then /tmp/etc/config/blink.sesbutton contains the command to enable it again) but neither seem to work. I can run the script from the administrative commands tab so I know it works but it wont run when I press the AOSS button for some reason. Am I missing something to enable this feature or is there anything extra I need to do for this router. I am running DD-WRT v24-sp2 (06/23/14) std - build 24461 and I do have the reset button enabled.
I was holding off on upgrading as I saw a couple people on the forums with issues using my router model and the later versions where as this build has been very stable for me so far, I have a few of these routers and have used them for various things. Is the upgrade 100% necessary to resolving this problem? Ill try it on one and see how it goes for now I guess but Id prefer to stay as stable as possible.
Ok, I have upgraded to the latest version and it does in fact solve the AOSS button issue but now I get no WAN IP and Ive tried everything I could find on the forum. Any ideas?
I've read about some Mediatek-based routers having that issue with newer builds.
If I'm remembering correctly, build 26138 should work. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Did you check that your Host AP doesn't have it's IP the same as your DD-WRT router ?
They must have different IPs for DHCP to work properly (if both have DHCP enabled). E.g: Host AP = 192.168.1.1 and DD-WRT router = 192.168.2.1 _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Then I'm sorry, I'm kinda out of ideas. You might try an even older build, which still has the WPS/SES/AOSS button working.
If you check the changelog in my signature you'll see that the WPS/SES/AOSS button was fixed in 25974 for Ralink/Mediatek. I would say to try 25974 first, see how things work. If it works well, then go step-by-step to newer builds: 26081, 26125.
Do not forget to reset to factory defaults before and after a new build and wait at least 2 minutes when doing so. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
I tried all the version from r25760 to r26653.I wonder if it is true.The PPPOE can not connect.
IN r25948,Pressing AOSS button turn off wifi LED,but radio is still work.
This is a good infomation ,from 25974 to 26653,AOSS can turn off wifi radio(if you set up in DD-WRT serive)
I have a buffalo wcr-gn,use as repeat AP.Today,I set up it into a router.find the
wcr-gn can not connect thith PPPOE.The router run the firmware in r26653.
