osypets
DD-WRT Novice
Joined: 12 Jul 2015
Posts: 1
|
 Posted: Sun Jul 12, 2015 11:27 Post subject: Unifi AC v2 |
 |
Hello!
Anyone know how to flash Unifi AC v2 to dd-wrt?
I'm tried flash with firmware from link below, but no success.
There is output from ssh session:
| Code: | BZ.v3.2.12# fwupdate.real -m dd-wrt-27506-unifiac-preflash.bin -d
Found mtd block: /dev/mtd0(boot)
Found mtd block: /dev/mtd1(linux)
Found mtd block: /dev/mtd2(rootfs)
Found mtd block: /dev/mtd3(linux2)
Found mtd block: /dev/mtd4(rootfs2)
Found mtd block: /dev/mtd5(cfg)
Found mtd block: /dev/mtd6(EEPROM)
Found mtd block: /dev/mtd7(nvram)
Adding partition: boot 1C000000 00040000
Adding partition: linux 1C040000 007A0000
Adding partition: linux2 1C7E0000 007C0000
Adding partition: cfg 1CFA0000 00040000
Adding partition: EEPROM 1CFE0000 00010000
Adding partition: nvram 1CFF0000 00010000
Calculating flash size:
Adding block: /dev/mtd0("boot") - size: 00040000
Adding block: /dev/mtd1("linux") - size: 007A0000
Skipping block /dev/mtd2("rootfs") - size: 006335E0, artificial: 1, unallocated: 0, writeable: 0(WRITEABLE: 400, flags: 800)
Adding block: /dev/mtd3("linux2") - size: 007C0000
Skipping block /dev/mtd4("rootfs2") - size: 006531DC, artificial: 1, unallocated: 0, writeable: 0(WRITEABLE: 400, flags: 800)
Adding block: /dev/mtd5("cfg") - size: 00040000
Skipping block /dev/mtd6("EEPROM") - size: 00010000, artificial: 0, unallocated: 0, writeable: 0(WRITEABLE: 400, flags: 800)
Adding block: /dev/mtd7("nvram") - size: 00010000
Total flash size: 01000000
Flash start: 1C000000
Flash end: 1D000000
Invalid Image MAGIC 'HDR0' |
Firmware used from this link - ftp://ftp.dd-wrt.com/betas/2015/07-09-2015-r27506/ubnt_unifi_ac/
Guys please help with this problem! Maybe i need some different firmware image?
Thanks a lot for help! |
|
