fotosdobrasil.fot.br DD-WRT Novice
Joined: 19 Dec 2011 Posts: 34
|
Posted: Sat Sep 12, 2015 15:54 Post subject: Port speed at HMI page, a good function to be added; |
|
Hi,
To now the speed of the physical ports on my router i need to login over telnet and run the command below:
Code: | swconfig dev eth0 show | grep link
|
The suggestion: To put in the "Lan" and "Wan" tabs the status of the Router physical ports (up/down, speed, half or full duplex, flow control...)
I use this information because my ISP is over optic fiber, my "specified speed" is over 100mb/s, but some times the speed of the wan link "goes" to 100 mega, a reset of the fiber optic modem and the speed returns to 1000 mega.
Before questions, the speed test result changes, with the wan operating in 100 mega i get something near of 90 mega on speed test. 1000 mega wan and the result increase to 160 mega over speed test copel (Brazilian speed test site).
To now how port is what on my router:
http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd
Best regards,
Leonardo |
|