Posted: Thu Jan 19, 2017 6:18 Post subject: DD-WRT Access Control question
Hi All,
I've a TP-Link WR841N that I've update the firmware using dd-wrt, I've set my tp-link to act as a Access Point as it connected to a GreenPacket WN-600 modem wifi which I could not update the firmware, I've tried using the Access Control option of my new update TP-Link, but still all device connected to that TP-Link able to access the internet even though I've Deny all internet access for the whole week.
Is there something that I need to do to make the Access Control work? I've already enabled the Policy that I've created and Apply the changes and Save it, but still does not work.
Posted: Thu Jan 19, 2017 15:08 Post subject: List of Clients
Did you add any thing to the List of Clients? An IP range, specific IP addresses, MAC addresses, etc. If you did not even add in the entire DHCP range than the restriction might be enabled but it does not apply to any device yet. _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch
I've added the ip and mac address of the device but still it can access the internet even though I deny all access in the access restriction. Please do help how to have the access restriction work.
Note: my tp-link is configure to be access point so DHCP is disabled.
