[Dratas]

Hello,i get cheap Buffalo WHR-G300N v2,flash in correct order,with correct flashing files,but is apear one small problem,that WAN port is not working that meaans always showing WAN 0.0.0.0,if i put LAN cable in to WAN,then i get same routers ip wich 192.168.1.35 and this lead to dd-wrt control panel and no working internet connection,if i put LAN cable in to LAN,then i get working internet,but WAN 0.0.0.0,so router acting like bridge.Firmware: DD-WRT v3.0-r30681 std (09/22/16)In Operating mode i set as Router,because is not main router,wich means internet coming via another device.Setup scheme is:ISP ubiquiti LOCO M2 wich can config only ISP,lan cat 5 cable to TP-LINK MR3220 this is main router,wich share internet in whole house,on near building is installed another LOCO M2 wich can i freely config without any restrictions,working like bridge and i able to catch wifi from MR3220 and use internet further,so the main problem is when i put cat5 lan cable into buffalo with dd-wrt into LAN i get WAN 0.0.0.0,but internet working,meanwhile when i put cable into WAN then no internet,but WAN catches buffalo internal IP,maybe somewhere need change MAC adress,what is need that WAN catch not 0.0.0.0 and i must have working internet connection.