Your reports for Ralink/Mediatek units are greatly appreciated !
Router:
Firmware:
Kernel:
Status:
Reset:
Errors:
This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build. Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless. If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Posted: Tue Feb 28, 2017 19:14 Post subject: D-Link DIR 615-D1 MAC Filter
Hi,
Router: DIR 615-D1
Firmware: DD-WRT v3.0-r31544 std (02/28/17)
Kernel: Linux 3.2.86 #26083 Tue Feb 28 08:06:28 CET 2017 mips
Status: Working
Reset: Yes
Previous: r31277 & r31533 (MAC Filter not working even on these)
Errors: MAC Filter seems to not work. Even if set "Enable" and "Permit only clients listed to access the wireless network", any client even NOT listed can access the wireless network
Router: Dlink DIR-810L A1
Firmware: DD-WRT v3.0-r31544 std (02/28/17)
Kernel Version: Linux 3.10.105 #2532
Status: Good
Reset: No
Errors: Maybe just a fluke, but on first reboot,5ghz appeared once and then disappeared. After manually re-applying 5ghz settings and rebooting once via gui, 5ghz is normal again,and been stable since. Wireless speeds acting normally, web gui is very responsive, WAN monthly traffic graph is working (values change as I download a large test file). Wireless signal quality values in status page seem normal again, (previously it was unusually high across the board)
Thank You DD-WRT devs!
CPU: Ralink MT7620A ver:2 eco:3
CPU Cores=1
CPU Clock
580 MHz