[egc]

@Nafmee, I was taught to leave "sourcenet" blank. If you want to specify the sourcenet (which is the IP range from the outside) you should specify it as an IP range with CIDR notation e.g. 72.16.7.0/24 (which gives the class C subnet permission to enter your router and be forwarded to your internal client)

[nafmee]

[BergRD]

33010 on my R7000 had very high TX errors, compared to earlier builds and rebooted both my 2.4ghz (2 wvlan) and 5ghz (solo) every 2 mins.

Initially was up and erased nvram and re-setup and everything thereafter rebooted the wlan's every 2 mins.

Tried to find a file/link to the 33000 STD for the R7000 but could not find on the official/unofficial repo's and wondering if anyone has the file they could host/send?

Again, looking for the 33000M STD for R7000.

If not, I reverted back to 31980 which is stable but got used to the updates on the 33000 build.

Thanks!

[tuddyma]

hi everybody,
just want to know if the firmware compiled with tproxy module?

thanks!

[slidermike]

tuddyma,
two things.
#1
Your question isn't specific to this revision of kong firmware so you should create a new thread.
#2
Did you search the forums before posting the question?
This thread might be useful.
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=269372

[memerchan]

Kong's new build DD-WRT v3.0-r32320M kongac 08/09/2017

Reset to factory:

I have ATT gigabit connection and test from Laptop from giga port directly to the modem: download average 770 upload 850

Same test but connect to my giga port on the buffalo's router:
download average 380 upload 600

Do i miss something?

Also I tested connect the moden on port 1 on my buffalo's rputer and my laptop in the second port and I was able to get download average 770 upload 800

Please help.

Thanks.

[slidermike]

Please create a new thread for support questions.
This thread is not for asking for help but rather your findings.
Putting down things like, how long your running the build; what build you upgraded from; what services work or don't (but not asking for support)

[slidermike]

Kong, this ver of test software has been out and tested by the community now for a month.
Are you planning on moving it to stable release and putting out a new test build?

[maguvu]

[mac913]

UPDATE...

I have this build running on 2x R7000 and a family members R7000 with over 25 days uptime and no down time. Yippy!!

Some of the issues I ran into, was one time the dnscrypt-proxy crashed on the family R7000 and lost DNS services. Also in the pass I have run into issues where the Internet connect cuts out after 5 to 7 days of uptime; unable to pin point if it's a build or modem issue. I have them ironed out with cron jobs to check WAN, VPN & DNS connections and restart them if needed.

[sideup66]

Hmmm have this firmware running happily in my r6300, haven't heard from Kong but I've seen him not update for a month or so... Not sure if he is debating leaving here or not though...

Anyone know what's up with him?

[mac913]