Template code to copy for posting a reply:
Code:
Router/Version:
Firmware:
Kernel:
Previous:
Mode/Status:
Reset:
Issues/Errors:
WARNING: This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build (e.g. 29000_NEWD-2_K2.6_mega-nv64k.bin). Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless. If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build.
Posted: Wed Sep 06, 2017 21:10 Post subject: Access restrictions not working on R7800
Just installed today with no issues. Install was clean.
Router/Version: Netgear R7800
Firmware: r33215m
Kernel: Linux 3.18.66 #171 SMP PREEMPT Sun Aug 20 18:16:57 CEST 2017
Previous: r33010m
Mode/Status: AP
Reset: No
Issues/Errors: Access restriction policies don't work on IP ranges, only discrete IP addresses. Had same issue in previous versions.