Posted: Sat Sep 16, 2017 6:58 Post subject: i need help to unbrik my C7 tplink V2
hi all
i have ddwrt installed in my C7 tplink v2 and all of the sudden it stop working and only the power light is on and none of the other lights are flashing and also the reset botton doesn't work any more... i though about connecting to my router via serial connection so i did the soldering and ready to check my router boot.
after i did the wire connection between the pc and the router and start PuTTy with the right configuration ... i fired up the router and the serial connection doesn't not show any boot ... its like dead router ....
Also, you may need a switch (can be an old router running dd-wrt set up as a switch) in between the Archer C7 and your computer. _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch