Posted: Tue Jan 30, 2024 21:51 Post subject: Canot set up D-Link Dir-300 rev.B as repeater bridge
I installed DD-WRT on D-Link Dir-300 rev.B, last build 44715 (https://dd-wrt.com/support/router-database/?model=DIR-300_B1). Looks like it works, I need it as a brdige repeater. Tried to set it up as reapeter several times. Every time I set all settings as repeater, router stops responding to any kind of access like WiFi or lan with cabel. A remark about lan connection - can't connect before setting up as repeater bridge with 8pin cable(tried several cables), but can with 4 pin.
Tried to install build for another router version, but only bricked it and got orange power led blinking. Revived it via emergency room interface.
Joined: 18 Mar 2014 Posts: 12923 Location: Netherlands
Posted: Wed Jan 31, 2024 20:27 Post subject:
To clarify on the router database page:
Quote:
DISCLAIMER
This database may not have up-to-date information and may even recommend a build which might cause issues. As such, you should check the device specific forum (Broadcom, Atheros, MediaTek, etc.) first before flashing any build recommended in this database. There you will find build specific topics that discuss any issues with a particular build/release. For more up-to-date firmware files, please visit the firmware faq.
We don't have to check anything.
Because we know exactly what is written on the page.
You just haven't read it.
Thank You, I searched in the wrong place! I found latest version for my router, as You wrote in previous comment, and installed it. Unfortunately it didn't change a thing. Every time I set it up in Repeater Bridge mode, click Save and after Apply then reboot - I have no more access to the router neither via wireless nor via cable. Laptop constantly tries to access DD-WRT, but no success.