Joined: 04 Oct 2007 Posts: 1258 Location: Ohio USA
Posted: Fri Mar 26, 2010 21:20 Post subject:
Legendary wrote:
Is there a way to tell if its a 1mb or 2mb flash without opening the case?
I got someone offering me this but I'll wont get it if I can't put DD-WRT on it.
No. Both the 1mb and 2mb versions have the same model/fcc id. The only option is to unscrew the 4 screws under the rubber feet and get the numbers off the chip. _________________ (05/02/17) std - 31924
Linksys WRT400N
Buffalo WHR-G300N
Thank you. I couldn't seem to clearly figure out how people were doing it. I think jtag is a little too ambitious for what I want. I guess unless someone figured a TFTP method, I'll stick with the crappy stock firmware.
Posted: Sun Sep 05, 2010 5:43 Post subject: Someone simplify this a little for me?
I have the WGR614 v6 TDC. I popped it open and am lucky enough to have the 160 chip that has the 2 MB Flash.
I have read through most of the installation files and this thread but what I am coming to is that there is not s simplish solution ATM.
Am I correct that there is not a way to get my router turned into a Wireless bridge ATM without having to solder?
If not could someone spell it out a little bit for me. I am intelligent and can follow directions well, but do not have much experience with this.
If it can be done but requires soldering and such could you break down what needs to be done for it to work? I have a friend at school who builds his own radio transmitters out of altoid boxes and chips he buys on the web. I bet he could help me change some chips on this board.
Is there a firmware out yet for the WGR614v6? It still says its a work in progress but was wondering if anybody heard anything about the firmware. Thanks.