Joined: 10 May 2008 Posts: 1380 Location: Pacific North West, USA
Posted: Mon May 18, 2009 0:36 Post subject:
Yes, it's a built-in recovery mode of the router.
So if you were to try different build, you can always reload a working one. _________________ Soylent Green Is People !
=-=-=-=-=-=-=-=-=-=-=
Netgear Nighthawk R7000 - DD-WRT Build R46220
Linksys EA8500 - OpenWRT IPQ806x Trunk R16375 5.4 Kernel
Joined: 10 May 2008 Posts: 1380 Location: Pacific North West, USA
Posted: Mon May 18, 2009 5:11 Post subject:
I only buy routers that will run DD-WRT
I never really liked the stock firmware versions
I bought the WHR-G300N just because DD-WRT had started supporting it
I launched it once normally, just to make sure it turned on,
then immediately flashed build 030309 on it
No newer builds have worked on it, 030309 is current latest working version. _________________ Soylent Green Is People !
=-=-=-=-=-=-=-=-=-=-=
Netgear Nighthawk R7000 - DD-WRT Build R46220
Linksys EA8500 - OpenWRT IPQ806x Trunk R16375 5.4 Kernel
Any serious problems with it running? I have heard mixed reviews about N working and not working, like that. Every different forum topic has a different conclusion is seems like.
This was working great (20090518 build) until I disconnected the power temporarily. The thing will not boot up after I set some DHCP static entries and NAT port forwards.
Joined: 10 May 2008 Posts: 1380 Location: Pacific North West, USA
Posted: Fri May 29, 2009 15:54 Post subject:
I would try a 30-30-30 reset a couple of times.
Then reload the latest 05/21/09 build via TFTP.
I am running 05/21/09 and rock solid connection,
great uptime, no issues with this whatsoever. _________________ Soylent Green Is People !
=-=-=-=-=-=-=-=-=-=-=
Netgear Nighthawk R7000 - DD-WRT Build R46220
Linksys EA8500 - OpenWRT IPQ806x Trunk R16375 5.4 Kernel
Posted: Fri May 29, 2009 16:28 Post subject: Problems with each ddwrt build for Buffalo WHR g300n
Hi, i have problems with every build i have found for Buffalo WHR g300n.
My ISP limits my connection to only one computer through mac address, pppoe and uses TTL limit, so i had to put ddwrt to this router to run ttl adjusting command for outgoing connections, but with every biuld when i clone mac, adjust PPPoe, wireless and ttl command and restart the router, then i cant ping the router again, cant access the webinterface and have to reset it. Can anyone tell me if this is a problem of the biulds or i dont do anything right.
Would aprriciate every answer.