[Nachtigall77]

No

[Nachtigall77]

06-08-12-r19342 - wi-fi still not working on our device

[LOM]

"doesn't work" does not count as an error report.

Lots of post about it and no one has given the output from dmesg after a reboot.

[Nachtigall77]

[Nachtigall77]

any suggestions?

[Blackmore]

And silence...
DD-WRT Guru, where are you?
I can not to believe, that no one can't fix current problems firmware!
Perhaps something can accelerate the solution of problems of the router?

[_Cyber_]

Does wifi work on r19519 ?

[Nachtigall77]

No

[Some0neElse]

Any news about wi-fi on bilds over 18007?

[calinm]

Hi,

Below is the dmesg output from ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2012/07-20-12-r19519/Asus-RT-N15/

The radio does not seem to work. "Site survey" shows nothing and I can't see the SSID from other devices. If you need other info about my router that may help you fix this, please let me know.

Thanks,

Calin

DD-WRT v24-sp2 std (c) 2012 NewMedia-NET GmbH
Release: 07/20/12 (SVN revision: 19519)

root@rtn15:~# dmesg
<5>Linux version 3.2.23-svn19518 (root@dd-wrt) (gcc version 4.6.3 20120201 (prer elease) (Linaro GCC 4.6-2012.02) ) #1373 Fri Jul 20 13:35:53 CEST 2012
<7>prom: fw_arg0=00000001, fw_arg1=0bbf3fb0, fw_arg2=0bbf43b0, fw_arg3=00000000
<7>argv[0]= (null) is invalid, skipping
<7>env[0]: memsize=32
<7>env[1]: initrd_start=0x00000000
<7>env[2]: initrd_size=0x0
<7>env[3]: flash_start=0xBC400000
<7>env[4]: flash_size=0x400000
<7>env[0]: memsize=32
<7>env[1]: initrd_start=0x00000000
<7>env[2]: initrd_size=0x0
<7>env[3]: flash_start=0xBC400000
<7>env[4]: flash_size=0x400000
<6>bootconsole [early0] enabled
<6>CPU revision is: 0001906c (MIPS 4KEc)
<6>Ralink RT2880 id:2 rev:1 running at 266.66 MHz
<6>Determined physical RAM map:
<6> memory: 02000000 @ 08000000 (usable)
<6>Wasting 1048576 bytes for tracking 32768 unused pages
<4>Zone PFN ranges:
<4> Normal 0x00008000 -> 0x0000a000
<4>Movable zone start PFN for each node
<4>early_node_map[1] active PFN ranges
<4> 0: 0x00008000 -> 0x0000a000
<7>On node 0 totalpages: 8192
<7>free_area_init_node: node 0, pgdat 88276ac0, node_mem_map 882e1000
<7> Normal zone: 64 pages used for memmap
<7> Normal zone: 0 pages reserved
<7> Normal zone: 8128 pages, LIFO batch:0
<7>pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768
<7>pcpu-alloc: [0] 0
<4>Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
<5>Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock4 rootfstype=sq uashfs noinitrd
<6>PID hash table entries: 128 (order: -3, 512 bytes)
<6>Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
<6>Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
<4>Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes.
<4>Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 16 bytes
<6>Memory: 29500k/32768k available (2132k kernel code, 3268k reserved, 391k data , 156k init, 0k highmem)
<6>NR_IRQS:48
<6>console [ttyS1] enabled, bootconsole disabled
<6>Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
<6>pid_max: default: 32768 minimum: 301
<6>Mount-cache hash table entries: 512
<6>NET: Registered protocol family 16
<6>bio: create slab <bio-0> at 0
<6>Switching to clocksource MIPS
<6>NET: Registered protocol family 2
<6>IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
<6>TCP established hash table entries: 1024 (order: 1, 8192 bytes)
<6>TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
<6>TCP: Hash tables configured (established 1024 bind 1024)
<6>TCP reno registered
<6>UDP hash table entries: 256 (order: 0, 4096 bytes)
<6>UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
<6>NET: Registered protocol family 1
<6>squashfs: version 3.0 (2006/03/15) Phillip Lougher
<6>msgmni has been set to 57
<6>io scheduler noop registered
<6>io scheduler deadline registered (default)
<6>Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
<6>serial8250: ttyS0 at MMIO 0x300500 (irq = 10) is a 16550A
<6>serial8250: ttyS1 at MMIO 0x300c00 (irq = 16) is a 16550A
<4>Ralink gpio driver initialized
<4>spidrv_major = 217
<6>system type: RT2880
<6>boot type: 0
<5>ralink flash device: 0x400000 at 0xbf000000
<6>Ralink SoC physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank . Manufacturer ID 0x0000c2 Chip ID 0x0022a8
<6>Amd/Fujitsu Extended Query Table at 0x0040
<6> Amd/Fujitsu Extended Query version 1.1.
<5>number of CFI chips: 1
<0>
<0>found squashfs at 132000
<5>Creating 6 MTD partitions on "Ralink SoC physically mapped flash":
<5>0x000000000000-0x000000030000 : "uboot"
<5>0x000000030000-0x000000040000 : "uboot-config"
<5>0x000000040000-0x000000050000 : "factory-defaults"
<5>0x000000050000-0x0000003e0000 : "linux"
<5>0x000000132000-0x0000003e0000 : "rootfs"
<4>mtd: partition "rootfs" must either start or end on erase block boundary or b e smaller than an erase block -- forcing read-only
<5>0x0000003e0000-0x0000003f0000 : "nvram"
<6>tun: Universal TUN/TAP device driver, 1.6
<6>tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
<6>PPP generic driver version 2.4.2
<6>PPP BSD Compression module registered
<6>PPP Deflate Compression module registered
<6>NET: Registered protocol family 24
<6>Ralink APSoC Hardware Watchdog Timer
<6>u32 classifier
<6> Performance counters on
<6> Actions configured
<6>Netfilter messages via NETLINK v0.30.
<6>nf_conntrack version 0.5.0 (460 buckets, 1840 max)
<6>ctnetlink v0.93: registering with nfnetlink.
<6>IPv4 over IPv4 tunneling driver
<6>ip_tables: (C) 2000-2006 Netfilter Core Team
<6>IPP2P v0.8.2 loading
<6>ipt_CLUSTERIP: ClusterIP Version 0.8 loaded successfully
<6>TCP bic registered
<6>TCP cubic registered
<6>TCP westwood registered
<6>TCP highspeed registered
<6>TCP hybla registered
<6>TCP htcp registered
<6>TCP vegas registered
<6>TCP scalable registered
<6>NET: Registered protocol family 17
<5>Bridge firewalling registered
<6>8021q: 802.1Q VLAN Support v1.8
<6>searching for nvram
<6>nvram size = 0
<0>initialize Realtek VLAN config
<4>MAC_ADRH -- : 0x00000000
<4>MAC_ADRL -- : 0x00000000
<4>Ralink APSoC Ethernet Driver Initilization. v2.0 256 rx/tx descriptors alloc ated, mtu = 1500!
<4>NAPI enable, Tx Ring = 256, Rx Ring = 256
<4>MAC_ADRH -- : 0x0000000c
<4>MAC_ADRL -- : 0x43288064
<6>VFS: Mounted root (squashfs filesystem) readonly on device 31:4.
<6>Freeing unused kernel memory: 156k freed
<4>rt2860v2_ap: module license 'unspecified' taints kernel.
<4>Disabling lock debugging due to kernel taint
<4>MAC_ADRH -- : 0x000090e6
<4>MAC_ADRL -- : 0xba7431a3
<4>
<4>phy_tx_ring = 0x091a7000, tx_ring = 0xa91a7000
<4>
<4>phy_rx_ring0 = 0x091a8000, rx_ring0 = 0xa91a8000
<4>CDMA_CSG_CFG = 81000000
<4>GDMA1_FWD_CFG = 10000
<6>device vlan1 entered promiscuous mode
<6>device eth2 entered promiscuous mode
<6>br0: port 1(vlan1) entering forwarding state
<6>br0: port 1(vlan1) entering forwarding state
<4>RtmpOSNetDevDetach(): RtmpOSNetDeviceDetach(), dev->name=ra0!
<6>br0: port 1(vlan1) entering forwarding state
<4>0x1300 = 00064380
<4>0x1300 = 00064380
<6>device ra0 entered promiscuous mode
<6>br0: port 2(ra0) entering forwarding state
<6>br0: port 2(ra0) entering forwarding state
<6>device vlan2 entered promiscuous mode
<6>device vlan2 left promiscuous mode
<6>br0: port 2(ra0) entering forwarding state
<6>etherip: Ethernet over IPv4 tunneling driver

[gnxredstar]

ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2012/10-12-12-r20119-testing/Asus-RT-N15/ latest testing successfully flashed on rt-n15 but still no wifi broadcast. LAN working

[_Cyber_]

Does wifi work on r20453 ?

[Some0neElse]

On svn 20548 wi-fi still don't work.

[John877]

Have the problems been worked out of the new versions?
Currently at r21286.

Im waiting to try this but need WiFi and PPPoE to work.