I managed to pick up an old one of these WGR614 v6 and the flash chip has:
MXS053011
29LV8008TTC-90
2M273200
I'm hoping the 2M means two megs.
But if so how do I go about trying to flash it?
I just tried to simply tftp the dd-wrt.v24-11762_NEWD_micro onto it but it didn't work. Where is the cfe image I should use for it and into what form should I compress it?
Posted: Fri Apr 24, 2009 8:04 Post subject: Is there a guide?
Hi there.
I have one of these routers, WGR614v6. I'm looking for a project to do.
I have not yet had the chance to crack it open to inspect the chip size, however I'm very keen to have a go at it, even if I need to solder on a bigger chip.
Since I am a novice, and have searched the whole DD-WRT forum for instructions on how this procedure is and well let's say it's beyond me.
I was hoping that maybe one of the guru's that have successfully got it to work could give a detailed instruction on how to go about upgrading the firmware on these things.
From which chip to actually take off and replace and which programs needed to upload firmware (I've played around with tftp for pxe a bit before)
Posted: Fri Aug 21, 2009 6:26 Post subject: 2MB Flash
I just got a v6 with 2MB flash for free. I want to put DD-WRT micro on it. Is there any way of putting it on without soldering? If not anyone here interested in it?
well.. my 614 also 1mb flash....
now im thinking of changing 4mb or larger size of Flash... izzit possible?? since i can get all this flash easily... 4mb 8mb 16mb... 32mb... etc etc..
Joined: 04 Oct 2007 Posts: 1258 Location: Ohio USA
Posted: Fri Aug 21, 2009 18:27 Post subject:
The person that did get it working, he flashed a CFE on his replacement chip with a chip programmer. Currently there is no way to do it with the web interface or tftp. _________________ (05/02/17) std - 31924
Linksys WRT400N
Buffalo WHR-G300N
Posted: Sat Oct 31, 2009 5:31 Post subject: wgr614 v6 had jtag port
i had add jtag and upgrade to 2m flash to wgr614 v6. i am now testing the wrt54gv5 cfe.bin, after power up and up load the dd-wrt.v24_micro, the router stall at Programming .... for long time. i will let router on over night and check it tomorrow
Posted: Sun Nov 01, 2009 9:13 Post subject: Re: wgr614 v6 had jtag port
tran_2q wrote:
i had add jtag and upgrade to 2m flash to wgr614 v6. i am now testing the wrt54gv5 cfe.bin, after power up and up load the dd-wrt.v24_micro, the router stall at Programming .... for long time. i will let router on over night and check it tomorrow
i will update the status.
good job...so how can i get some info on wgr614's jtag port, i opened the box, only serial port is available...
They are not pins, just 6 little copper pads in the rolls on the back (about 1/16 of an inches diameter). you need to add 4 4.7k pull up resistor to RP1 and 0.1k to R23. I got my running with latest ddwrt, but like "myacct" said, there are couple problems. a) WAN and LAN port 4 need to swap in vlan tab. b) The reset button did not work, I use gpio poll x to test but none of poll test responds all show 01 on press or not. BS and Sash had any other idea? Thank