read the serial debricking post in the peacock announcement #6. _________________ I fix "shortcuts". If you don't have time to read thoroughly, I don't have time to re-type what you missed.
I just purchased a audio to USB cable and plug the cable according to this post https://forum.openwrt.org/viewtopic.php?id=16733&p=2, unfortunately, I am unable to see anything using Hyper Terminal. My router is wrt610n v2. I tried just about everything and currently running out of clues. Does anyone have a clue to what is happening....why I am not getting anything when the terminal is plug and the router is turn on. Please assist with this. The router at this point has the power light just flashing because I convert it to an E3000 and then downloaded the wrong firmware. Ever since the power light just flash on and off repeatedly. Thank you for any assistance.
I soldered small pieces of cable onto the serialport pads, connected to usb-to-serial (CP2102 USB 2.0 to UART TTL 6PIN Module Serial Converter from ebay)
Didnt get anything over serial port, but after a while I disconnected 3.3v and shit started to flow over serial output as soon as router was plugged in.
Followed Hans_it instuctions except I had to break the boot procedure with ctrl-c instead of Enter