Posted: Mon Nov 23, 2009 22:33 Post subject: Question about Repeater Bridge.
So I have a Buffalo WHR-HP-G54 as the AP & a Linksys WRT54GS v6 as the repeater, all is good. So when I go look for a wifi signal I get two from both routers(dd-wrt & dd-wrt_vap) but I just want them as 1, I have done my research and linked both routers with WDS(put the main router's wifi mac address into the 2nd and vice versa) but I still get the same two signals. Both of them are on the same channel & I put in the correct MAC addresses.
Remove the virtual lan on the wireless basic setup page.
Better yet, do a hard reset and reconfigure both routers. _________________ SIG:
I'm trying to teach you to fish, not give you a fish. If you just want a fish, wait for a fisherman who hands them out. I'm more of a fishing instructor.
LOM: "If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.."