Got a new dir-825-revb2 these days and put the 17201 on it. After having found out about changeset 18810 i risked upgrading to 19342.
Wireless still working!
I switched off ath1 though, because i don't need it at the moment and it's only working at 13 dBm. In my apartment i can connect with my SGSII to ath1 but only at a distance roughly up to 5 meters. With ath0 i have connection everywhere.
Radio Radio is On
Channel 8 (2447 MHz)
TX Power 19 dBm
Rate 300 Mb/s
Is it possible to boost the ath0 TX power a little bit? Because even in my small apartment i have troubles getting a stable connection with my SGSII (android 4.0.3).
BUT, with my previous router it was even worse.
Now i've got to read a lot of documentation because i'm completely new to DD-WRT.
There could be other things causing the problem. The density of access points in an apartment complex is normally pretty high. You should try inSSIDer (http://www.metageek.net/products/inssider/) or something like it if you've not done something to look at the channel usage already.
Printer on USB Port does nothing. USB Light on front of router is out. Has not come back on since the dd-wrt flash. Emergency Flash screen will no longer come up using the reset button 10/10/10 or 30/30/30. Refuses to flash back to stock firmware.
Am happy with dd-wrt if can get USB port to work with my printer again???
Posted: Thu Jul 12, 2012 9:34 Post subject: I give up...
The first thing that happened when I flashed to dd-wrt was i lost my boot loader screen. I then tried everything posted eveywhere to try to flash back to stock firmware with no luck. Also lost the USB port. Something evidently went wrong when I flashed it to dd-wrt newest version. DD-wrt comes up with its settings & everything, but cannot live without the USB support. Looks like it was just a bad flash & looks like a JTag flash is the only thing left to put it back to stock firmware with working Boot Loader Screen & working USB port for this one. Hope you had better luck than I did.
I had it running until i couldn't get IPv6 working so i reverted back to stock firmware _________________ D-Link DIR-825 B1 / DD-WRT v3.0-r33215 std (08/25/17)
Netgear R7000 / DD-WRT v3.0-r33215 std (08/25/17)
Has anyone (in addition to bbun1508) updated DIR-825 rev B2 to latest 19342? Is it working fine?
I've been having minor WLAN problems with r17201. I've been trying to create virtual WLAN using this wiki: Multiple WLANs. When I connect to virtual WLAN, clients in physical interface start getting disconnected... I'm hoping that r19342 could solve this...