Posted: Fri Nov 28, 2014 16:40 Post subject: control + c
Nikopol2014 , if u cand see the mesages u showed my in your log, the parameters in putty are ok,otherway u could not see nothing there. putty had to be open, prepared before u power on the router.The comand has to be send in the first 2 or 3 seconds after power on, before the message "decompresing done"...so ...long story short : prepare putty , power on the router and repeatly press very quik cntrl+c.the is no other trick.good luck, hope u will made it.
Probably on my cable was not working rx or I installed incorrect drivers. I took a homemade com-usb from a friend and successfully restored the router.
I Have router 311 tenda.. was working fine. but on day it stops working and only power 1 LED is on and doesnot go further.
and then I connected serial i got following screen only and stops there.