Is it possible to create a client bridge using both the 5GHz and 2.4GHz radios simultaneously?
I can set it up to use one or the other successfully but, if I turn them both on client bridge, it seems to take the entire network down until I power down the client bridge router.
Just looking for maximum throughput on the bridge. Details below.
Router 1:
Connected to internet.
DHCP server on, pool starts at 100
DD-WRT v24-sp2 (05/27/13) big
2.4GHz AP mode WPA2+AES SSID: Test2.4
5GHz AP mode WPA2+AES SSID: Test5
IP: 192.168.2.1
Router 2:
DD-WRT v24-sp2 (05/27/13) big
2.4GHz Client bridge mode WPA2+AES SSID: Test2.4
5GHz Client bridge mode WPA2+AES SSID: Test5
DHCP off
IP: 192.168.2.2
Gateway: 192.168.2.1
DNS: 192.168.2.1
Everything unchecked in "Block WAN Requests"
SPI firewall disabled
Advanced routing to router