ASUS WL-500GP dead after flash with DD-WRT

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware
Goto page Previous  1, 2, 3, 4
Author Message
rj.2001
DD-WRT User


Joined: 20 Jul 2006
Posts: 88
Location: Dresden

PostPosted: Wed Jul 26, 2006 12:36 am    Post subject: restore instruction for WL500gP's Reply with quote
If your WL500gP no respond to a ping or if you can't flash again via ASUS firmware restoration do the following:

    Open the case (screws are under the rubbers)
    Remove the cover inside with a little screwdriver
    Short PIN 9 or the marked solder point to ground (e.g. to the outside of the power connector) with a cable and a needle.
    Turn the WL500gP on for approx 5 Seconds.
    Turn the WL500gP off
    Remove the short circuit bridge
    Turn the WL500gP on by holding the reset button
    Now, you can flash again Smile

Be care: don't short cut PIN 8 or PIN 10! It will destroy the device! At the best you use the marked solder point!

This instruction works fine for my WL500gP. To make it easier for other peoples I make this picture.

Good luck!



Hardware-Recover WL500gP.jpg
 Description:
WL500gP
 Filesize:  932.43 KB
 Viewed:  5673 Time(s)

Hardware-Recover WL500gP.jpg


Sponsor
peter_weber69
DD-WRT Novice


Joined: 25 Jul 2006
Posts: 8

PostPosted: Wed Aug 02, 2006 12:32 pm    Post subject: Reply with quote
hi

thx so much at all who find out the pin 9 Shocked method.
i can't belive it, my asus wl-500gp is alive.

@rj.2001, thank you so much for the picture.
i'm so happy Very Happy

Horst
01subaru25rs
DD-WRT Novice


Joined: 31 Jul 2006
Posts: 2

PostPosted: Thu Aug 03, 2006 3:43 am    Post subject: Reply with quote
I would like to say thank you also for the picture and the excellent instructions. I have debricked my WL-500gP! Now if I can only find a stable dd-wrt later than July 27 with VPN..
rj.2001
DD-WRT User


Joined: 20 Jul 2006
Posts: 88
Location: Dresden

PostPosted: Thu Aug 03, 2006 9:16 pm    Post subject: Reply with quote
Thanks for the nice words.
I wrote a HowTo for the WL500gP and the WL500gx:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=2507
I hope this helps peoples with bricked units.

V23_SP2 01.08.and higher works fine. No reboot-loops etc. Smile
Goto page Previous  1, 2, 3, 4 Display posts from previous:    Page 4 of 4
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum