Thanks you Eko ,after I change from opera ,IE8 to firefox 3.6
now I can flash it back to original firmware, if there any think I can help you please tell me
Tried everything to revive this router...including the following:
Doing a 30/30/30 hard reset
Setting my IP to 192.168.2.x & Gateway to 192.168.2.1
Setting my IP to 192.168.1.x & Gateway to 192.168.1.1
Holding down WPS button to enter CFS webserver
Holding down Reset button to enter CFS webserver
Everything has no result...
Not sure what to do from here
Edit: I WAS able to revive this router with by loading the stock firmware. If you were brave like me...and attempted to flash Eko's first build and bricked your router, follow these steps to load the stock firmware back on to the router. (NOTE THIS IS FOR BELKIN PLAY (F7D4302-V1) ONLY)
1. Download the stock firmware from http://en-us-support.belkin.com/app/answers/detail/a_id/3584
2. Make sure your Play router is unplugged and your ethernet cable is connected to it
3. Set your IP address to 192.168.2.8
4. Set the subnet mask to 255.255.255.0
5. Set your default gateway to 192.168.2.1
6. HOLD DOWN THE RESET BUTTON ON THE BACK OF THE ROUTER AND DO NOT LET GO
7. PLUG IN YOUR ROUTER WHILE HOLDING THE RESET BUTTON DOWN
8. KEEP HOLDING FOR 10 SECONDS
9. WHILE STILL HOLDING THE RESET BUTTON - OPEN YOUR BROWSER TO http://192.168.2.1
10. WHEN YOU SEE THE PROMPT FOR CFE miniWebserver you may let go
11. From here you can load the stock firmware you downloaded in step one
This worked for me...dodged a bullet AGAIN
Try using this method to get into CFE miniWebserver. If that doesn't work, follow the same procedures and use the WPS button instead of the reset button.
I still no luck ,I flash Eko's build 3302 via cfe web page and it acting strange ,
1) brick and not response for ip .1.1 or .2.1
2) after I press reset to enter cfe web ,after that I reset power many time it still active cfe web until I click reboot button
Eko newest build is work ,flash direct from belkin webUI and here is cfe.bin that you request ,I wait for megabuild that support s for SMB file sharing and printer sharing if it possible
Joined: 10 May 2008 Posts: 1380 Location: Pacific North West, USA
Posted: Tue Sep 14, 2010 15:18 Post subject:
qwe186 wrote:
nattapan wrote:
I have BELKIN SHARE F7D3402 ADSL 2/2+ can use this dd-wrt.v24-15172_NEWD-2_K2.6_mini-f7d3302.bin to flash it ?
dd-wrt can not use with built-in modem model
No - If anything DD-WRT would turn that modem/router combo just into a router
DD-WRT won't support the modem part, so you would lose that functionality.
Official word is no support on Modem/Router combo's _________________ Soylent Green Is People !
=-=-=-=-=-=-=-=-=-=-=
Netgear Nighthawk R7000 - DD-WRT Build R46220
Linksys EA8500 - OpenWRT IPQ806x Trunk R16375 5.4 Kernel
Joined: 31 Aug 2009 Posts: 2448 Location: Third Rock from the Sun
Posted: Wed Sep 15, 2010 14:31 Post subject:
Thank you, I gues I browsed too fast, I totally miss that, and didn't even think about googleing the ram chip. So thx for helpin out a lazy a$$ _________________ Peacock Thread-FAQ -- dd-wrt Wiki