Posted: Sat Dec 01, 2018 20:44 Post subject: WR741ND web gui not responding after a while (client bridge)
Hello,
I wanted to use this device (TP Link TL-WR741ND v4.25) as a repeater, so I set up a Client Bridge and virtual AP. The problem is, after few hours of uptime, I can't get into the web control panel. Browser says it took too long to respond. Pinging in CMD gets timeout. However, it's still working normally, and in the device that it's connecting to (WR841ND) I see it's connected. After rebooting everything works again, but few hours and it's unaccessible again. I really don't know what could be causing this, please help me.
I tried different builds: 37305, 36527, 36247
Everytime after flash I reset factory settings.
I changed these settings :
Local IP 192.168.0.5
Gateway 192.168.0.1 (main router, the one that it's connecting to)
Local DNS 192.168.0.1
Client Bridge mode, Default GW mode: manual 192.168.0.1
Made VAP
Set correct security
Operating mode: Router (default is Gateway)
Hi, I tried some builds, even the latest one (38060), but I still have the same problem. Do you think this could be caused by some bad configuration? Is there a way to show you my full config (like a export from router settings)? Thanks