Buffalo WZR-1750DHP wl1 Missing from GUI

Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware
View previous topic :: View next topic  
Author Message
mazecreator
DD-WRT Novice


Joined: 09 May 2009
Posts: 48
PostPosted: Sun Aug 27, 2017 20:42    Post subject: Buffalo WZR-1750DHP wl1 Missing from GUI Reply with quote
I updated 2 Buffalo WZR-1750DHP routers to R33215 and one decided to hide the Physical Interface wl1 [2.4 GHZ] GUI configuration. Any way to get this back? Is there a NVRAM setting? I requested "RESET" on both units when I did the update.
Back to top View user's profile Send private message
Sponsor
mazecreator
DD-WRT Novice


Joined: 09 May 2009
Posts: 48
PostPosted: Sun Aug 27, 2017 20:58    Post subject: Reply with quote
I think I got the GUI back, not sure why, but after factory reset one router was at 800MHz, the other (troublesome one) was at 600 MHz.

The 800MHz unit Firmware read: DD-WRT v3.0-r33215 std (08/25/17)
The 600MHz unit Firmware read: DD-WRT v3.0-r33215 (08/25/17)

The STD was missing from the defective unit, once I reset the Frequency to 800MHz and restarted, the troublesome unit showed the Wireless GUI again.
Back to top View user's profile Send private message
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum