FYI,
I flashed Build 21676 (STD-Nokaid) to my E1000 V1, and have had no issues thus far, save for the fact that Over/Under clocking doesn't work. The option wasn't even available before, so this comes as no surprise.
Link directly to the build I used
FYI,
I flashed Build 21676 (STD-Nokaid) to my E1000 V1, and have had no issues thus far, save for the fact that Over/Under clocking doesn't work. The option wasn't even available before, so this comes as no surprise.
Link directly to the build I used
Thanks for the share. I work with a bunch of these little gems. Are you able to verify that you are able to achive full 300mbps wireless n on this firmware? Or at least successfull 40mhz speeds above 150mbps?
FYI,
I flashed Build 21676 (STD-Nokaid) to my E1000 V1, and have had no issues thus far, save for the fact that Over/Under clocking doesn't work. The option wasn't even available before, so this comes as no surprise.
Link directly to the build I used
Thanks for the share. I work with a bunch of these little gems. Are you able to verify that you are able to achive full 300mbps wireless n on this firmware? Or at least successfull 40mhz speeds above 150mbps?
I'll check the network speeds a bit later today, but I probably will not be able to check N-band speeds. I'll see though.
It's definitely an awesome router. So much better than the one I'm using as an access point (WRT54G2 V1).
Assumptions:
1. Everyone on the forum has read the relevant forum section announcements.
2. For Broadcom section we have ALL at least tried to understand the "Peacock" thread,HERE