The switch-robo module seems not to be loaded after an insmod. I don't see it in lsmod and the folder proc/switch is empty. I also try to make a insnmod switch-core like described in a earlier post.
I tried but without success, the proc/switch folder is still empty. Here is what I've done:
-I activated jffs in dd-wrt GUI
-I downloaded the file switch-robo-e3000-gcc412.zip posted by cron2 Wed Feb 09, 2011 16:57 and extracted switch-robo.ko
-I copied it with winscp/ssh to the folder /jffs
-I ran the following commands
chmod a+r /jffs/switch-robo.ko
rmmod switch-robo
insmod switch-core
insmod /jffs/switch-robo.ko
but no folders were created in proc/switch and i don't see switch-robo with lsmod. Did I miss something?
@Malitiacurt : i read the tomato shibby website, and it seems my router (wrt610n v1) is not compatible. In the router list there is the wrt610n V2 but not the V1. Is it risky to flash my V2 with the tomato V1 build? Will it brick it?
Before buying another router, do you know if it is possible to use the switch robo module of this thread with a wrt610n v1? Or is it definitely incompatible?
I'm not a pro of dd-wrt so I'm just applying the procedures described in this thread, I'm not capable of modifying the code. So I wanted to know if I can use the module posted by cron2 without changes.
The module load seems OK because I can see "roboswitch: Probing device eth0: found a 53125!" in dmesg and I can see 128 vlans in /proc/switch/eth0/vlan/
Can someone confirm this module is working with the Linksys E3200 ?
The firmware is DD-WRT v24-sp2 (05/27/13) big (SVN revision 21676) (dd-wrt.v24-21676_NEWD-2_K2.6_big-nv60k.bin)
Hi all
I read this thread but my limited english and null vlans skills stick me in the vlanid 4097 .
So please, say me if from those days I could have the vlan id 100 working on a buffalo whr-g54s.
I flash it with the same mini-generic or voip builds than the wrt54gl, and I need to have it set up as a WAP, but it is not very important if I cannot/would not "assign wan port to switch".
Before buying another router, do you know if it is possible to use the switch robo module of this thread with a wrt610n v1? Or is it definitely incompatible?
I'm not a pro of dd-wrt so I'm just applying the procedures described in this thread, I'm not capable of modifying the code. So I wanted to know if I can use the module posted by cron2 without changes.
Posted: Sat Jan 30, 2016 17:36 Post subject: Patched module for ARM/ Asus RT87U
Hi all,
first of all thank for this thread this saved me lot of time gave me lot of inside info of vlan ddwrt. So here is my contribution.
I am from Dubai my ISP is Etislat, recently I moved to new apartment and new FTTH connection. previously I didnt have any issue with Vlan VID, for new setup I have to give VID 30 for PPPoE link. I read the whole thread and managed to recompile the kernel module for my device ( asus ac87u / Linux 4.4 ) with switch robo patched for 32 instead of 16. Everything is working fine when combined with the below jffs + startup script
Is reaally neeed add patch if i need to vlans on wan .16 (ppoe) and .50 (static ip)
i have rt-ac87u can some body write commands i need for interfaces.