Posted: Fri Dec 13, 2019 10:55 Post subject: WR1043N Wireguard Missing
Hi. I've installed dd-wrt on my router (WR1043N v2.1) and when I go to Configuration>Tunnel, no Wireguard protocol type option is present, only RFC3378 and Mikrotic. How i can setup Wireguard?
Firmware: DD-WRT v3.0-r41686 std (12/10/19)
Thanks
Yeahuh tis strange -- Wireguard is on these broadcomy units:
Linksys E2500
LInksys E1200v2
Asus RTN12D1
however
Wireguard NOT shown in r41686 on (atheros) Linksys WRT160NL
and I even reset the ol girl and all but it just don't show up
In my signature at the bottom of this page is a link to a Wireguard setup guide and scripts
I tried that link, but ended with a wonder where to put the PIA stuff...
otherwise to set a Wireguard to work with router to a phone is not my goal...
and yep if installed via Entware than is there a user guid via CLI..or commands and so on...how to set up and call it...
In fact not much stuff via Entware has a guide or commands how to...
Wireguard not present on 1043v2 neither... _________________ Atheros
TP-Link WR740Nv1 ---DD-WRT 55630 WAP
TP-Link WR1043NDv2 -DD-WRT 55723 Gateway/DoT,Forced DNS,Ad-Block,Firewall,x4VLAN,VPN
TP-Link WR1043NDv2 -Gargoyle OS 1.15.x AP,DNS,QoS,Quotas
Qualcomm-Atheros
Netgear XR500 --DD-WRT 55779 Gateway/DoH,Forced DNS,AP Isolation,4VLAN,Ad-Block,Firewall,Vanilla
Netgear R7800 --DD-WRT 55819 Gateway/DoT,AD-Block,Forced DNS,AP&Net Isolation,x3VLAN,Firewall,Vanilla
Netgear R9000 --DD-WRT 55779 Gateway/DoT,AD-Block,AP Isolation,Firewall,Forced DNS,x2VLAN,Vanilla
Broadcom
Netgear R7000 --DD-WRT 55460 Gateway/SmartDNS/DoH,AD-Block,Firewall,Forced DNS,x3VLAN,VPN
NOT USING 5Ghz ANYWHERE
------------------------------------------------------
Stubby DNS over TLS I DNSCrypt v2 by mac913