Posted: Sat Jan 08, 2011 18:29 Post subject: adding antenna to TEW-647GA adapter ???
where and how to i add a antenna to TEW-647GA adapter. i opened it up and this is what the front and back look like. looks like theres a trace on the pcb that is the antenna? but im not sure. If i can add a pigtail to solder on where would it be ?
The antennas on the circuit board look like a pair of dipoles fed with a balanced lines.
If you can explain how to disassemble the TEW-647GA adapter without breaking it I may be able to open mine and have a closer look.
sure. its not that hard to open. theres a rubber ring on the bottom to prevent slips. peel that off carefully and theere will be two small screws on the bottom. then peel the indicator sticker which shows LED activity. then the rest is just carefully prying it open since the casing is held on with clips.
I opened mine also. Anyone have any luck?
Also, I was wondering if the small copper connector under what appears to be the antenna that is molded into the board is of any use-