barrywilson DD-WRT Novice
Joined: 15 Jun 2010 Posts: 5
|
Posted: Sat Feb 26, 2011 21:08 Post subject: Need gpio3 alternative for whr-hp-g54 (soldering damage) |
|
SD5 (gpio 3) involves a solder to a bare square etching on the board. The tiny square etching fell off the board.
What can I do?
There are two large squares for an unused LED4, and to the right of that there are two tiny squares for a resistor. The rightmost tiny square appears to be the one that needs to be soldered, and that's the one that fell off.
At this point, the router still functions as normal, but I would like to complete the SD mod. Can the other tiny square be used instead? Or better, can one of the big squares from LED4 be used?
This is the board. |
|