This page will discuss the GUI Configuration of the Routers Switch(Ethernet Ports).
Medium
DD-WRT NXT provides high-level control over the underlying configuration for the available switch ports
The default configuration interface looks as following:
Per default, all ethernet ports are assigned to LAN, every attached device is part of the LAN-Network per default.
A need for configuring the switch ports may be, that you want to move a LAN Port, to the WAN-Network. One might have a setup similar to:
Ethernet-PC1—-(PORT 1)DD-WRT NXT(WAN)—-MODEM
Where PC1, should be in the same Network, as the WAN side of your DD-WRT NXT router and the Modem.
The GUI configuration would look as follows:
With this configuration, the PC1 will now receive an IP from the Modem or the DHCP Server in the WAN-Network, if the setup provides this
Not available, yet