Router Model: TPLINK WR1043ND V2
Firmware Version: DD-WRT v3.0-r30949 std (12/15/16)
Kernel Version: Linux 3.18.45 #3077 Thu Dec 15 06:31:31 CET 2016 mips
Status: so far OK
Reset: no
Errors: Openvpn not working, and sometimes while accessing the attached storage from different network devices the router freezes then reboots.
Last edited by Handyone on Sat Jan 14, 2017 19:11; edited 1 time in total
EA8500
DD-WRT v3.0-r30949 std (12/15/16)
Linux 3.18.45 #113 SMP PREEMPT Mon Dec 12 22:51:40 CET 2016 armv7l
run this for about 8 hours seemed 'bout good as any other.
-----
WNDR3700 V4
DD-WRT v3.0-r30949 (12/15/16
Linux 3.18.45 #3093 Thu Dec 15 06:55:45 CET 2016 mips
NO Reset --- installed over 30534 on my backup unit
using as main router
to start ath1 and now both radio work ok on HT40 as the original config was set.
Made a change in the GUI on admin page just a bit ago. After apply settings it killed the 5GHz so
I'm just sayin you will have to kick start ath1 again after your done mucking around with things.
working ok aside from mentioned and some other in the tatsuya46 list
uptime 2:32
---
EDIT: dd-wrt_30949 still too big for these guys
8061952 bytes wrt160nl-firmware.bin
8061952 bytes e2100l-firmware.bin
Last edited by mrjcd on Fri Dec 16, 2016 12:10; edited 1 time in total
Joined: 24 Jan 2016 Posts: 130 Location: Midwest, US
Posted: Fri Dec 16, 2016 3:24 Post subject:
Router: Buffalo WZR-600DHP
Firmware: 30949
Kernel: 3.10.104 #4531 Thu Dec 15 04:18:09 CET 2016 mips DD-WRT
Status: OK
Reset: No
Errors: 5GHz broken, works on 20MHz, but not wide 40MHz channel width _________________ Buffalo WZR‑600DHP (WZR-HP-AG300H)
WNDR3700 V4
DD-WRT v3.0-r30949 (12/15/16
Linux 3.18.45 #3093 Thu Dec 15 06:55:45 CET 2016 mips
NO Reset --- installed over 30534 on my backup unit
using as main router
ath1
(RX) 104172 OK, no error
(TX) 134313 OK, no error
ath0
(RX) 2719486 OK, no error
(TX) 4823549 OK, no error