alfador DD-WRT Novice
Joined: 13 Jun 2017 Posts: 1
|
Posted: Tue Jun 13, 2017 18:33 Post subject: Help with first x86 installation - DHCP not working (r32170) |
|
I'm trying to get DD-WRT running on a PC.
I have a PC with a Gigabyte Motherboard, with one Integrated NIC and a PCI Intel PRO/1000 dual LAN NIC.
My Lynksys router recently died so I have the PC running Windows 10, and sharing my internet connection.
I have my Cable modem connected to Port 1 of the Intel PRO/1000, and the Port 2 goes to a Netgear Switch.
The integrated NIC is disabled in the bios.
Under Windows, everything works fine. All computers on my network can access the internet and other computers on the network.
I downloaded betas › 2017 › 06-01-2017-r32170 › x86dd-wrt_public_vga.image 59.23 MB 2017-06-01.
Flashed on a USB Stick.
Booted the computer from the USB Stick.
DD-WRT seems to boot fine, but I eventually get these messages every few seconds :
gethostbyname: Network is unreachable
connect: Network is unreachable
connect: Network is unreachable
connect: Network is unreachable
running ifconfig at the console shows that Eth0 has a default IP address (does not get a IP from the ISP) and Eth1 has 192.168.1.1.
The computers on the network do not get a DHCP address from DD-WRT.
I tried configuring a Pc on the network with a static Ip, but the DD-WRT web interface remains inacessible. 192.168.1.1 does not responds to ping.
I used this config for the static IP :
IP : 192.168.1.2
Mask : 255.255.255.0
Default Gateway : 192.168.1.1
Another thing I noticed : all the light on every used port the Netgear switch flash synchronously. I would expect random flashing.
Any ideas for me?
Thank you! |
|