I've modified the header of the DD-WRT 27506 factory-to-ddwrt build intended for TL-WA801ND v1, so that it will flash on a TL-WA701ND v1 running stock TP-Link firmware.
If the attached build works for you, it can be further updated with any newer-than-27506 webflash build for TL-WA801ND v1.
Disclaimer: I haven't tested the attached build myself, so I'm not responsible in any way if you brick your router.
Please only flash this build if you know how to unbrick it.
Hey,
To install it, I have just to go to firmware upgrade (via web) then upload your file and upgrade it?
Posted: Mon Jan 22, 2018 21:41 Post subject: Re: It works!
Not-Aus wrote:
I can confirm that it works flawlessly with the TL-WA701ND v1.2!
First I installed the newest available TP-Link firmware, then I installed the modified TL-WA801ND v1 firmware, available one post above.
The default IP of the device is 192.168.1.1 with DHCP enabled after flashing.
Note, that after flashing DD-WRT you CANNOT access your device via LAN. Only via WLAN (Wi-Fi). You must fix this manually.
Connect to AP via Wi-Fi, set login and password, then DISABLE WAN and check "Assign WAN Port to Switch" option in Setup tab.
After that I successfully updated the device to the latest DD-WRT webflash which is available today.
It can be found here:
Posted: Mon Mar 19, 2018 15:15 Post subject: Re: It works!
Not-Aus wrote:
I can confirm that it works flawlessly with the TL-WA701ND v1.2!
First I installed the newest available TP-Link firmware, then I installed the modified TL-WA801ND v1 firmware, available one post above.
The default IP of the device is 192.168.1.1 with DHCP enabled after flashing.
Note, that after flashing DD-WRT you CANNOT access your device via LAN. Only via WLAN (Wi-Fi). You must fix this manually.
Connect to AP via Wi-Fi, set login and password, then DISABLE WAN and check "Assign WAN Port to Switch" option in Setup tab.
After that I successfully updated the device to the latest DD-WRT webflash which is available today.
It can be found here: