Posted: Thu Feb 22, 2018 13:47 Post subject: how create guest network Dlink-DIR600 rev b ?
Hello my friends
Good Morning
I would like some help from you, because I can not create a wifi guest network on this router. I followed several tutorials on youtube of similar firmware but it does not work. I can even create the wifi network but it does not surf, there is no internet because something is not right in the configuration. Could you help me?
I want to disable the default Wi-Fi network of this router and leave only the guests and the networks do not talk. anyone accessing the guest network will not have access to my local network. understood
I'm waiting
thank you so much.
Dlink-DIR600 rev b
Firmware: DD-WRT v3.0-r33772 std (11/16/17)
Hi i followed the instructions in the link you provided and i have some problems.
If i'm already connected to my home network and then tries to connect to the guest network, i do not have any internet access. This is same vice versa.
Good afternoon friends
unfortunately I did everything that you suggested and it does not work.
I followed several topics, tutorials, videos in youtbe, and it does not work.
I can connect in the virtual network, but I can not navigate, there is no internet.
the settings I made were identical, connect in the network with another ip, but without internet.
I do not know what else to do. this my router is in dhcp mode disabled. is just a repeater for my room to work on the local network through the cable, but I want to use my cell phone on his wifi only where it has a different network from my local network.
who distributes ip is my server
192.168.0.1 - main router with internet
192.168.0.3 - server
192.168.0.40 - router from my room connected with the cable on the lan port
I created the virtual network with ip 192.168.1.1
enabled dhcpd on RA1 interface
below are the information that shows me on the WIFI tab
Wireless Physical Interface wl0 [2.4 GHz]
Physical Interface ra0
when I create the virtual network, enable the ra1 interface
I believe that this part is correct because it distributes IP, the same problem is in navigation that does not exist.
iptables -I FORWARD -i wl0.1 -d `nvram get lan_ipaddr`/`nvram get lan_netmask` -m state --state NEW -j REJECT
that's right
it is not the default gateway.
it's just a wifi signal repeater and cable for my pc
but I would like his wifi to transmit the internet to another network other than my local network
How do I have to configure this?
and how do I change the information of your command regarding the interfaces that my router stipulates?
Joined: 18 Mar 2014 Posts: 12889 Location: Netherlands
Posted: Thu Mar 08, 2018 8:52 Post subject:
Did you read my notes?
It is is in there:
If you place the VAP on a wireless access point (a secondary router with a disabled WAN, no DHCP and on the same subnet as a the primary router) then you have to add the following rule to the firewall in order to get internet access from the VAP.
In the web-interface of the router: Administration/Commands save Firewall:
It is is in there:
If you place the VAP on a wireless access point (a secondary router with a disabled WAN, no DHCP and on the same subnet as a the primary router) then you have to add the following rule to the firewall in order to get internet access from the VAP.
In the web-interface of the router: Administration/Commands save Firewall:
Good morning mate
finally worked out.
I did not know that I had to make more advanced configurations, because I do not understand commands and firewall. now with this command worked. it was just that. this router is secondary with dhcp disabled and cable connected to the LAN port.
but I had to put my main gateway in the configuration to be able to run internet only if it only connected to the wifi but did not browse.
Thank you so
