Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Mon Apr 30, 2018 2:30 Post subject:
deeproot wrote:
This build would not let me connect to the internet when I used my saved config even if I said wipe it and loaded it after the flash.
wrt3200acm
If you are saying you used a backup after resetting the configuration you have not really done anything. What you need to do is to reset the configuration, as you said wipe, and then reconfigure. Using a backup just creates the same configuration that may have issues as you already had.
--bill _________________ Unifi Security Gateway:Unifi Firmware Netgear r7800:Voxel Firmware Modem:Netgear CM500V voice and Data. ISP:Comcast tutorial for flashing "WRT" series: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813 DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117 Kong DD-WRT Config Tutorial: http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/ I tried to be normal once. Worst 2 minutes ever.
WRT1900ACS (v1&v2) tangent post - I noticed there are new Linksys firmwares released. Not that I'm planning to use it (I did archive a copy in case of course), just sharing in case it was useful info. My apologies if this should have been a different post.
Otherwise, tangent2, I'm mending fine from my bike accident - thanks again for the positive thoughts.
I'm feeling perky enough that if a new DD-WRT build came out I was going to go for it.
Info on the Linksys firmware from release notes - same changes listed:
https://www.linksys.com/us/support-article?articleNum=165487
*V1*
Product: Linksys WRT1900ACS
Classification: Firmware Release Notes
Firmware version: 1.0.3.187766
Release date: April 20, 2018
- Patched WPA2 KRACk vulnerabilities when operating in Wireless Bridge or Wireless Repeater modes
- Updated the wireless driver to drv_7.2.9.2.p11_fw_7.2.9.27
- General bug fixes
- Patched WPA2 KRACk vulnerabilities when operating in Wireless Bridge or Wireless Repeater modes
- Updated the wireless driver to drv_7.2.9.2.p11_fw_7.2.9.27
- General bug fixes
Linksys has been busy last month.
They also had new stock firmware for the WRT1900AC - both v1 and v2 - with similar release notes.
I've been running the new stock firmware on my WRT1900ACv1 and using it as an AP.
Been very stable for almost 2 weeks.
Note that they have restricted 5GHz to lower frequency bands and no more 80 width. _________________ ------------------------------------
Linksys WRT3200ACM DD-WRT r55819 (Gateway)
Linksys EA8500 OpenWrt-23.05.3 (Wired AP)
Netgear WNDR3700v4 DD-WRT r55819 (spare Gateway)
Photos: https://www.flickr.com/photos/nickant44/albums