Setting port to 10MBit FullDuplex/FD doesn't work

Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware
View previous topic :: View next topic  
Author Message
mkl
DD-WRT Novice


Joined: 13 May 2008
Posts: 2
PostPosted: Tue May 13, 2008 8:24    Post subject: Setting port to 10MBit FullDuplex/FD doesn't work Reply with quote
When trying to set a port to 10MBit FullDuplex mode I didn't get any effect although the checkboxes were correct (my equipment: Linksys WRT54GS V1.1 with DD-WRT v24 RC-7 (04/25/0Cool mega). Transfer rates with my dBox in 10MBit FD mode were approximately 600-700 KBit/s.

I've double-checked with "robocfg show" which reported unchanged settings that deviated from the settings made via the WebGUI of dd-wrt. Using "robocfg" I was able to make a workaround (resulting transfer rates are now about 8,5 MBit) but I hope that there is a better solution.

mkl
Back to top View user's profile Send private message
Sponsor
mkl
DD-WRT Novice


Joined: 13 May 2008
Posts: 2
PostPosted: Thu May 15, 2008 17:48    Post subject: RE: Setting port to 10MBit FullDuplex/FD doesn't work Reply with quote
My dBox is modified to work in 10 MBit FD mode, therefore the switch must work in the same mode, because the dBox doesn't support autonegotiation.
Back to top View user's profile Send private message
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum