[majinsoftware]

Iv got radar turned off and channel selected is 1 (since theres no one on that channel)

It will stay on the selected channel for a few hours then it always jumps up to 6 or 13 which are heavly populated already.

[Sash]

more input

read:

[majinsoftware]

Every thing reset to default.

Selected Regulatory Domain New Zealand

Then changed antenna to diversty on and tx,rx secondary.

Save

Then channel selected 1

(radar is disabled on default so left it disabled)

Save, Apply.

After 2 hours check the status page and its changed its self to channel 6 or 13. Just randomly jumps to one of them.

What more do you want it says firmware version for my 2610 in my sig.
And iv read every page or the wiki and iv already done a search if any ones had this problem before that how I know to have radar mode disabled.

[Sash]

try to install the lastest beta

[majinsoftware]

Had it on since last night. And had logging on.
I think Iv found the source of the problem.

Some ones been trying to crack it with aireplay.
I can reproduce the problem by using backtrack and

aireplay -0 99 -a AP mac -h client mac interface

Jam that for a few mins and then AP will switch channel.

Is that a feature of "Noise Immunity"

[Sash]

i dont know. i think not. but who knows. the dev's told me that the channel switching problem in fixed channel use is fixed. but who knows how it will react under an attack