brano DD-WRT Novice
Joined: 12 Sep 2012 Posts: 1
|
Posted: Thu Sep 13, 2012 19:35 Post subject: ECB-9500 / ECB-9750 console info |
|
The console is on the 6 pin connector, starting from front of the unit:
Pin 1: 3.3V
Pin 2: GND
Pin 3: Rx
Pin 4: Tx
Pin 5: ?
Pin 6: ?
Speed: 57600 8N1
Console log after boot with stock firmware 2.3.3
Code: |
U-Boot 1.1.3 (Nov 20 2008 - 18:00:37)
Board: RT2880 DRAM: 32 MB
relocate_code Pointer at: 8bfa8000
twe0 set to <NULL>
toe0 set to <NULL>
Default FLASH_CS1_CFG = 0511FFA1
Ready Set Value = 0x0511FFA1
Setup FLASH_CS1_CFG = 0511FFA1
CAS 3 (D1835272)
EN_ID_29LV640H, Size = 00800000 bytes
Set info->start[0]=BC000000
AMD Read Mode, flash reset,triger at BC000000
flash_protect ON: from 0xBC400000 to 0xBC42522F
protect on 64
protect on 65
protect on 66
monitor protection ON by default,monitor_flash_len = 152112
ENV protection ON by default !!
flash_protect ON: from 0xBC430000 to 0xBC43FFFF
protect on 67
D-CACHE set to 4 way
I-CACHE set to 4 way
##### The CPU freq = 266 MHZ ####
SDRAM bus set to 32 bit
SDRAM size =32 Mbytes
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
5: Load ucos code to SDRAM via TFTP.
2 1 0
3: System Boot system code via Flash.
## Booting image at bc450000 ...
Image Name: Linux Kernel Image
Created: 2012-03-13 9:12:20 UTC
System Control Status = 0x02910084
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1030357 Bytes = 1006.2 kB
Load Address: 8a000000
Entry Point: 8a196040
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 8a196040) ...
## Giving linux memsize in MB, 32
Starting kernel ...
THIS IS ASIC - VERSION B
ramsize = 32 MBytes
rambase not set, set to default (0x08000000)
MEMORY DESCRIPTOR dump:
[0,8a275cc0]: base<0a000000> size<02000000> type<Free RAM memory>
PROC INIT OK!
init started: BusyBox v1.7.5 (2012-03-13 17:11:12 CST)
starting pid 10, tty '/dev/console': '/sbin/config_init'
Config Init version: 2.3.3.471 date: 2012/03/13
starting pid 55, tty '/dev/ttyS1': '/sbin/config_term'
************************************************************************
* ECB9500 *
************************************************************************
KernelApp/Ramdisk Ver:2.3.3.471 Date:2012/03/13
console>
|
|
|