Posted: Thu Oct 27, 2011 11:03 Post subject: iPTV flood the WLAN - la TVinternet inonder le WIFI
Bonjour,
Depuis plusieurs mois j'ai le WIFI qui plante après que j'ai regardé la TV avec la box de mon FAI.
J'ai fait des recherches et j'ai trouvé 3 tutos qui traitent le sujet. J'ai essayé les 3 mais pour l'instant rien ne marche. Je parle pas encore très bien anglais, j'ai utilisé un traducteur pour essayer de comprendre mais ce n'est pas évident et leur interface ne coresspond pas exactement à la mienne (le wifi est bridgé sur mon WRT54GL de linksys)
There are two methods for running separate IP ranges on each of the interfaces which yield two rather dissimilar results.
[edit] iptables Method
Rather than splitting up br0, some may find it adequate to use the Iptables command to allow routing between two subnets on the LAN/WLAN side. Since br0 is not being split up, there are no/fewer problems caused in the web interface. The major draw back to this is that if wireless users statically assign an IP on the LAN ip address range, the bridge will allow them access. A trick might be to set the WLAN ip range to the default (192.168.1.x) and the LAN ip range to something odd (10.15.25.x, or 192.168.152.x or something) to prevent WLAN users from guessing the ip range.
You can use any private ip ranges you would like, but for this example I will use 192.168.1.x for the LAN ports and 192.168.2.x for the WLAN port.
Basic Steps:
Enable a static route for 192.168.1.x to vlan0
Enable a static route for 192.168.2.x to eth1
Enable DHCP for 192.168.1.x for vlan0
Enable DHCP for 192.168.2.x for eth1"
Pour faire un nouveau DHCP c'est pas difficile mais pour créer une route statique je bloque.
Ce que j'ai compris c'est qu'il faut cocher la case unbridged interface eth1 dans setup>Networking.
Puis il faut créer une route statique pour eth1 et vlan0. Mais je ne sais pas ce qu'il faut mettre dans les cases.
Pour l'instant j'ai mis ça:
1()
LAN
0
192.168.1.0
255.255.255.0
192.168.1.1
vlan0