Posted: Thu Feb 23, 2012 18:07 Post subject: Re: [DIY] Configure OpenVPN on newer releases DD-WRT (GUI St
i have a silly question, but where can i get this version of the firmware? when i look at the database on dd-wrt i can only find the version 14896 for my wrt54 gs v1.1....
Everything just works now from the improved GUI and is very simple...
Hi
I have a couple of questions about this :
1) if I want to channel all my LAN traffic through the VPN, the Daemon mode must be used and not the client mode?
2) there's no rules at all in the management console, the GUI takes all in charge?
on Arethusa site, they give the following instructions :
Go to Administration -> Commands.
Enter these 3 lines in "Commands":
iptables -I FORWARD -i br0 -o tun0 -j ACCEPT
iptables -I FORWARD -i tun0 -o br0 -j ACCEPT
iptables -A POSTROUTING -t nat -o tun0 -j MASQUERADE
I too am having terrible luck getting a client config file to work with the settings mentioned by the OP.
Anybody have any luck with this configuration and willing to post up a copy of their client config file? Obviously after you remove/change sensitive info.
Posted: Mon Oct 22, 2012 10:33 Post subject: Re: OpenVPN simple Setup Guide
MumboJumbo wrote:
Just to clarify, this documentation is "AS IS" and is only an indication as to "what to-do" when setting up OpenVPN on newer releases of dd-wrt.
Remember, that Server Settings must be used on client side!
Example: LZO Compression server side = Yes
Then Client side = LZO Compression = Yes.
Enable client to client, if you need clients to see eachother, and remember that the VPN Ip scope must be able to handle the amount of clients.
Server Config:
Client Config:
If your setup is running, and suddenly stops, after changing some settings. Use SSH to the router and look at the log file, for errors as these might not be shown on the WebGUI
Sometimes, the apply settings, messes up keys/certificates and nothing shows on Status page, try re-applying the keys and reload.