Joined: 29 May 2015 Posts: 15 Location: Frankfurt, Germany
Posted: Fri Jun 05, 2015 12:37 Post subject:
PsuFan wrote:
Can you test your lan port #2 and see if it works?
Unfortunately, not! I forgot to test it before the flashing, and it is not just #2. Ports are doing weird things. After reboot, they are stopping right after the firmware has been loaded, so I have to reboot again with unplugged cords and after power led stops flashing to plug them again in.
I am a bit disappointed of this router. The only good thing is the powerful Wi-Fi signal.
hmm, my Ports 1,3 and 4 work just fine, gigabit. And I tested my port 2 before I flashed and it was working. BrainSlayer forgot to configure the LAN ports on the E1700, so hopefully he will configure them soon in an update to get your ports working.
Posted: Wed Jun 10, 2015 2:06 Post subject: Re: can't install ddwrt on e1700
technik wrote:
2). Downgrade the firmware of your router to 1.0.0.0
thanks, this does help re-install dd-wrt on my e1700.
i had flashed back the FW_E1700_v1.0.01.008_20141028.bin from dd-wrt, then i can't get back to dd-wrt, it always popup saying that "incorrect firmware file" at around 30%.
so, after downgrade the firmware back to FW_E1700_v1.0.00.081_20131220.bin, then only i can successfully install dd-wrt, again. thanks technik.
oops, not sure if i misleading...
i meant i upgraded from an already install dd-wrt e1700...
hmmm... i reverted it from dd-wrt back to linksys but updated firmware (v1.0.01).
p/s once install dd-wrt, in order to revert back to linksys original firmware instead of dd-wrt, just press and hold the reset button for 20 seconds, then flash the linksys firmware at the "emergency firmware upgrade" page.
yup, i flashed 3 linksys e1700, all port 2 seem like not working.
i used them as WDS.
for the "WAN Connection Type", i can't put "Disabled", else, all the ports can't access the router, but, if i use "wireless" connection, i can access the router.
Cancel my above request, I wasn't logged in so didn't see the download attachment in an earlier post, but I see it now since I've logged in to make the post
off to do some flashing, fingers crossed it all works