Now that the E6350 appears to be supported, has anyone been able to flash their routers with this?
I tried through the WebGui but it says the image is too big.
Have you tried to first flash to an older Linksys firmware and then flash DD-WRT from there ?
I see EA6350 is supported since 28139, have you tried to flash 28139 ?
Edit: Also please see your messages (upper right corner of dd-wrt page) I've sent you a PM. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Now that the E6350 appears to be supported, has anyone been able to flash their routers with this?
I tried through the WebGui but it says the image is too big.
Have you tried to first flash to an older Linksys firmware and then flash DD-WRT from there ?
I see EA6350 is supported since 28139, have you tried to flash 28139 ?
I have not tried to flash the stock EA6350 to an older Linksys firmware. I didn't know that was possible.
The issue I'm running into is that the 28139 EA6350 build is over 25mbs in size and Linksys throws an error that the image file is too big.
The router also doesn't respond to TFTP requests from my Win8 PC.
Can you link a firmware that I can try and flash to then go to DD-WRT? I understand with this model performing the 30-30-30 reset is not advisable.
Just need a little guidance and I should be good. I am also thinking of posting the how to for this model after I get it running.
I would recommend to update to 1.0.4 from the link above, but it might still not allow DD-WRT to be flashed. And then you can't go back to 1.0.3...
I don't know how to fix this, but I've read that EA6400 had the same issues.... let me check. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
I will standby on my current version in case I can't go back.
I was reading somewhere that the TFTP flash portion on these routers is right when it boots up, but it has to be timed perfectly and I have not had any luck with this.
Any ideas about flashing to a micro (or other version of DD-WRT) that fits the size requirements then flashing to the current build?