Posted: Mon Aug 14, 2017 16:18 Post subject: Linksys E3000 router and static leases
I tried to configure an E3000 Linksys router for Static Leases.
I just configured 25 static ip addresses and press the Save / Apply Settings.
When I tried to verify, the router did not give the addresses from the static leases or from the DHCP addresses.
After I delete the static leases to 17, the router works properly.
It seems that the E3000 limits the maximum number of static leases to 17 independent of the firmware.
Is there a maximum number of Static Leases for the other routers, like the E2500 or E1500?
Thanks
Posted: Mon Aug 14, 2017 23:05 Post subject: Re: Linksys E3000 router and static leases
BIT22 wrote:
I tried to configure an E3000 Linksys router for Static Leases.
I just configured 25 static ip addresses and press the Save / Apply Settings.
When I tried to verify, the router did not give the addresses from the static leases or from the DHCP addresses.
After I delete the static leases to 17, the router works properly.
It seems that the E3000 limits the maximum number of static leases to 17 independent of the firmware.
Is there a maximum number of Static Leases for the other routers, like the E2500 or E1500?
Thanks
You should post in broadcom forum ----- and NO the E2500 has NO problem doing many more static leases than that as
long as the IPs set are within the range of the subnet set on main setup page .... or IPs are within range of
other interface subnet you may have setup....... No one can tell you much until you provide the exact firmware
you have installed --- some builds may/may not work well on your router.